Product Categories

Sanitary Stainless Steel Horizontal Pneumatic Cross Ball Valve

Sanitary Stainless Steel Horizontal Pneumatic Cross Ball Valve

Body Material 304&316L
Connections  Clamp, weld, thread,DIN,SMS,ISO,IDF,BPE,RJT
Working Pressure  10 bar
Working Temperature -30℃-150℃
Application Beverage, brewing, oil refining, cosmetics, and chemical industries
Size 1/2“ -4”,DN10-DN100
Surface Ra≤0.5μm

Product  Description

A Sanitary Stainless Steel Horizontal Pneumatic Cross Ball Valve is a ball valve equipped with a pneumatic actuator. Pneumatic actuators are relatively fast and do not require workers to do the work themselves, saving human resources and time to a great extent.


1.Fluid resistance is small, and its resistance coefficient is equal to the same length of pipe section.

2.Simple structure, small volume and light weight.

3.Close and reliable, the sealing surface material of the ball valve is widely used plastic, good sealing, and has been widely used in vacuum systems.

4.Easy to operate, rapid opening and closing, from fully open to fully closed as long as the rotation of 90 °, to facilitate remote control.

5.In the fully open or fully closed, the sealing surface of the ball and valve seat is isolated from the medium, the medium through the valve will not cause the erosion of the sealing surface.


The INOXCN GROUP CORPORATION’s Sanitary Stainless Steel Horizontal Pneumatic Cross Ball Valves have been widely used in petroleum, chemical, power generation, paper, atomic energy, aviation, rocket and other sectors, as well as people’s daily life.

Sanitary Butterfly Valves Weld End with Pull Handle maintenance, use and installation instructions

1.Before installation and use of pneumatic ball valve, the valve must be checked before installation and switch operation test. Only under the condition of normal operation, the valve can be installed and used.

2.The installation of pneumatic ball valve should be concentric as far as possible so that the valve and pipeline flange, and support fixed. The ball valve can not be subjected to other external forces, so as not to damage the valve in the seal and valve deformation. The valve switch does not work and the damage to the valve can not be used.

3.To ensure that the pneumatic ball valve and pneumatic components to provide the power source must be clean, as far as possible without oil and water. The cleanliness should be less than 0.4 micron.

4.Before accessing the air source, the air supply pipeline, air source interface and switches and other devices must be cleaned to prevent dirt and sediment from rushing into the pneumatic actuator unit due to unclean pipeline and causing failure.

5.The connection of pneumatic actuator, solenoid valve, positioner, filter, pressure reducing valve, etc. can be made with copper or nylon pipe. In order to prevent dust and reduce noise, the exhaust port should be installed with muffler or muffler throttle.

6.After installation, the pneumatic valve should be tested, pressurized to the rated value of the pneumatic actuator, the pressure is 0.4 ~ 0.7mpa, the pneumatic ball valve switch test, observe the opening and closing of the valve. It should rotate flexibly without jamming phenomenon. If there is a jam in the switch can be increased air pressure, repeatedly switch the valve to the switch can be flexible.

7.installation and commissioning of the switch type pneumatic ball valve, the first manual device (solenoid valve on the manual button) debugging, after the normal operation of the power on debugging.

8.Pneumatic ball valve should be regularly maintained valve stem rotation, should be three months oil (oil) once. Regularly on the pneumatic actuator unit and with the use of the air filter for water, sewage. Under normal circumstances six months to check once, once a year overhaul.

We are professional manufacturers of sanitary stainless steel horizontal pneumatic cross ball valve, we specialize in sanitary valves for more than 15 years!

Sanitary Stainless Steel Horizontal Pneumatic Cross Ball Valve.pdf

Get a Quote